Reference Guide

244 Power over Ethernet Commands
www.dell.com | support.dell.com
power inline powered-device
The power inline powered-device Interface Configuration (Ethernet) mode command adds a
comment or description of the powered device type to enable the user to remember what is
attached to the interface. To remove the description, use the no form of this command.
Syntax
power inline powered-device pd-type
no power inline powered-device
• pd-type — Specifies the type of powered device attached to the interface. (Range: 1-24
characters)
Default Configuration
This command has no default configuration.
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
There are no user guidelines for this command.
Example
The following example configures a description to an IP-phone to a powered device connected
to Ethernet interface 1/e1.
power inline priority
The power inline priority Interface Configuration (Ethernet) mode command configures the
inline power management priority of the interface. To return to the default configuration, use
the no form of this command.
Syntax
power inline priority {critical | high | low}
no power inline priority
• critical — Indicates that operating the powered device is critical.
•
high — Indicates that operating the powered device has high priority.
•
low — Indicates that operating the powered device has low priority.
Console(config)# interface ethernet 1/e1
Console(config-if)# power inline powered-device IP-phone