Reference Guide

158 Ethernet Configuration Commands
www.dell.com | support.dell.com
Example
In the following example, automatic crossover is enabled on port 1/e5.
back-pressure
The back-pressure Interface Configuration (Ethernet) mode command enables back pressure
on a given interface. To disable back pressure, use the no form of this command.
Syntax
back-pressure
no back-pressure
Default Configuration
Back pressure is enabled.
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
• Back pressure cannot be configured on trunks.
Example
In the following example back pressure is enabled on port 1/e5.
clear counters
The clear counters User EXEC mode command clears statistics on an interface.
Syntax
clear counters [ ethernet interface | port-channel port-channel-number ]
•
interface — Valid Ethernet port. (Full syntax: unit/port )
•
port-channel-number — Valid port-channel number.
Console(config)# interface ethernet 1/e5
Console(config-if)# mdix auto
Console(config)# interface ethernet 1/e5
Console(config-if)# back-pressure