Reference Guide

Ethernet Configuration Commands 151
Ethernet Configuration Commands
interface ethernet
The interface ethernet Global Configuration mode command enters the interface configuration
mode to configure an Ethernet type interface.
Syntax
interface ethernet interface
• interface — Valid Ethernet port. (Full syntax: unit/port )
Default Configuration
This command has no default configuration.
Command Mode
Global Configuration mode
User Guidelines
There are no user guidelines for this command.
Example
The following example enables configuring Ethernet port 5/e18.
interface range ethernet
The interface range ethernet Global Configuration mode command configures multiple
Ethernet type interfaces at the same time.
Syntax
interface range ethernet { port-range | all }
•
port-range — List of valid ports. Where more than one port is listed, separate non-
consecutive ports with a comma and no spaces, use a hyphen to designate a range of
ports.
•
all — All Ethernet ports.
Console(config)# interface ethernet 5/e18