Reference Guide

234 PHY Diagnostics Commands
www.dell.com | support.dell.com
Examples
The following examples display the optical transceiver diagnostics.
Console# show fiber-ports optical-transceiver
Power
Port Temp Voltage Current Output Input TX Fault LOS
---- ---- ------- ------- ------ ----- ------- ---
1/g1 W OK E OK OK OK OK
1/g2 OK OK OK OK OK E OK
1/g3 Copper
Temp – Internally measured transceiver temperature.
Voltage - Internally measured supply voltage.
Current – Measured TX bias current.
Output Power – Measured TX output power.
Input Power – Measured RX received power.
Tx Fault – Transmitter fault
LOS – Loss of signal
N/A - Not Available, N/S - Not Supported, W - Warning, E - Error
Console# show fiber-ports optical-transceiver detailed
Power
Port Temp Voltage Current Output Input TX Fault LOS
[C] [Volt] [mA]
[mWatt] [mWatt]
---- ---- ------- ------- ------ ----- ------- ---
1/g1 48 5.15 50 1.789 1.789 No No
1/g2 43 5.15 10 1.789 1.789 No No
1/g3 Copper
Temp – Internally measured transceiver temperature.
Voltage - Internally measured supply voltage.
Current – Measured TX bias current.
Output Power – Measured TX output power.
Input Power – Measured RX received power.
Tx Fault – Transmitter fault
LOS – Loss of signal