Reference Guide

Clock 127
Syntax
sntp client enable
no sntp client enable
Default Configuration
The SNTP client is disabled on an interface.
Command Mode
Interface configuration (Ethernet, port-channel, VLAN) mode
User Guidelines
• Use the sntp broadcast client enable Global Configuration mode command to enable
broadcast clients globally.
• Use the
sntp anycast client enable Global Configuration mode command to enable anycast
clients globally.
Examples
The following example enables the SNTP client on Ethernet port 1/e3.
sntp unicast client enable
The sntp unicast client enable Global Configuration mode command enables the device to use
the Simple Network Time Protocol (SNTP) to request and accept SNTP traffic from servers. To
disable requesting and accepting SNTP traffic from servers, use the no form of this command.
Syntax
sntp unicast client enable
no sntp unicast client enable
Default Configuration
The SNTP unicast client is disabled.
Command Mode
Global Configuration mode
Console(config)# interface ethernet 1/e3
Console(config-if)# sntp client enable