User's Manual

78 Removing and Installing Parts
Installing a Floppy Drive
1 If you are installing a new drive:
a Use a small flat-edge screw driver on the back side of the drive-panel insert to gently pop off the
insert.
b Remove the four shoulder screws from the drive-panel insert.
2 If you are replacing an existing drive:
Remove the four shoulder screws from the existing drive.
3 Insert the four shoulder screws into the sides of the new floppy drive and tighten them.
4 Attach the power and floppy-drive cables to the floppy drive.
5 Align the shoulder screws with the screw guides, and slide the drive into the bay until it clicks into
place.