User's Manual
Table Of Contents
- Dell Latitude 10 – ST2e Owner's Manual
- Working on Your Computer
- Removing and Installing Components
- Recommended Tools
- Internal View
- Removing the Base Cover
- Installing the Base Cover
- Removing the Battery
- Installing the Battery
- Removing the Front Camera
- Installing the Front Camera
- Removing the Speakers
- Installing the Speakers
- Removing the Docking Board
- Installing the Docking Board
- Removing the System Board
- Installing the System Board
- Removing the Rear Camera
- Installing the Rear Camera
- Removing the Coin-Cell Battery
- Installing the Coin-Cell Battery
- Removing the Volume-Button Board
- Installing the Volume-Button Board
- System Setup
- Troubleshooting Your Computer
- Specifications
- Contacting Dell
4. Press the Security Button (<Ctrl> + <Alt> + <Del>) to click OK once the tests are completed.
5. The volume up and down buttons can also be used as the <Tab> key when switching between options.
Beep Codes
The computer may emit a series of beeps during start-up if the display cannot show errors or problems. These series of
beeps, called beep codes, identify various problems. The delay between each beep is 300 ms, the delay between each
set of beeps is 3 seconds, and the beep sound lasts 300 ms. After each beep and each set of beeps, the BIOS should
detect if the user presses the power button. If so, BIOS will jump out from looping and execute the normal shutdown
process and power system.
Code
Cause and Troubleshooting Steps
1 BIOS ROM checksum in progress or failure
29