User's Manual
Table Of Contents
- Dell Latitude 10 – ST2e Owner's Manual
- Working on Your Computer
- Removing and Installing Components
- Recommended Tools
- Internal View
- Removing the Base Cover
- Installing the Base Cover
- Removing the Battery
- Installing the Battery
- Removing the Front Camera
- Installing the Front Camera
- Removing the Speakers
- Installing the Speakers
- Removing the Docking Board
- Installing the Docking Board
- Removing the System Board
- Installing the System Board
- Removing the Rear Camera
- Installing the Rear Camera
- Removing the Coin-Cell Battery
- Installing the Coin-Cell Battery
- Removing the Volume-Button Board
- Installing the Volume-Button Board
- System Setup
- Troubleshooting Your Computer
- Specifications
- Contacting Dell
b) battery
3. Disconnect the volume-board cable from the connector. Lift up and remove the volume-board cable from the
system board.
4. Pry the sides of the volume-button board with a flat-head screw driver to loosen it from it's slot on the computer.
Remove the volume-button board from the computer
Installing the Volume-Button Board
1. Place the volume-button board in it's slot on the computer.
2. Route and connect the volume-board cable to the connector.
3. Install the:
a) battery
b) base cover
4. Follow the procedures in
After Working Inside Your Computer
.
19