User's Manual
Table Of Contents
- Dell Latitude 10 – ST2e Owner's Manual
- Working on Your Computer
- Removing and Installing Components
- Recommended Tools
- Internal View
- Removing the Base Cover
- Installing the Base Cover
- Removing the Battery
- Installing the Battery
- Removing the Front Camera
- Installing the Front Camera
- Removing the Speakers
- Installing the Speakers
- Removing the Docking Board
- Installing the Docking Board
- Removing the System Board
- Installing the System Board
- Removing the Rear Camera
- Installing the Rear Camera
- Removing the Coin-Cell Battery
- Installing the Coin-Cell Battery
- Removing the Volume-Button Board
- Installing the Volume-Button Board
- System Setup
- Troubleshooting Your Computer
- Specifications
- Contacting Dell
Installing the Speakers
1. Place the right and the left speakers in their slot.
2. Route the speaker cables on the chassis.
3. Tighten the screws to secure the speakers to the chassis.
4. Place the coin-cell battery in its slot and route the cables.
5. Connect the speaker connector cable to its port on the system board.
6. Install the :
a) battery
b) base cover
7. Follow the procedures in
After Working Inside Your Computer.
Removing the Docking Board
1. Follow the procedures in
Before Working Inside Your Computer
.
2. Remove the:
a) base cover
b) battery
c) speaker
d) front camera
3. Lift up the connector latch and disconnect the docking-board power cable from the connector.
14