Users Guide

7 Route the SAS data cable through the clip on the card and through the channel on the inner side of the chassis.
8 Attach the connector labeled "BP SAS" to connector SAS A on the backplane, and attach the connector labeled "CTRL SAS" to SAS-
cable on the controller card.
9 Close the sled.
10 Insert the sled into the MX chassis and turn on the system and any attached MX chassis peripherals.
Removing the HBA330 mini monolithic controller
CAUTION: Many repairs may only be done by a certied service technician. You should only perform troubleshooting and simple
repairs as authorized in your product documentation, or as directed by the online or telephone service and support team.
Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that are shipped with your product.
1 Turn o the system, including any attached peripherals, and disconnect the system from the electrical outlet and peripherals.
NOTE: It is recommended that you always use a static mat and static strap while working on components in the interior of
the system.
2 Open the system.
3 Locate the HBA card on the system board
4 To disconnect the storage controller cable:
a Remove the two screws that secure the cable to the card.
b Grasp the cable on both sides of the cable connector, and pull the cable up and away from the HBA card.
5 Angle the card so that the other end of the card disengages from the storage-controller card holder on the system board.
6 If applicable, replace the storage controller card and connect the cable. For more information on installing the card, see Installing the
HBA330 mini monolithic controller.
7 Close the system.
8 Reconnect the system to its electrical outlet and turn the system on, including any attached peripherals.
Deploying Dell HBA cards
23