Users Guide

Figure 10. Removing and installing the HBA330 card
1
bracket notch (3) 2 release lever
3 card bracket 4 tabs on the system
5 system chassis 6 card connector on the system board
7 HBA card connector
Installing the HBA330 MMZ adapter card
CAUTION
: Many repairs may only be done by a certied service technician. You should only perform troubleshooting and simple
repairs as authorized in your product documentation, or as directed by the online or telephone service and support team.
Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that are shipped with your product.
1 Turn o the sled and any attached peripherals, and remove the sled from the MX chassis.
NOTE
: It is recommended that you always use a static mat and static strap while working on components in the interior of
the system.
2 Open the system.
3 Align the bracket notches with the tabs on the sides of the system and align the HBA card connector with the connector on the
system board.
4 Press the HBA card onto the connector until it is rmly seated.
5 Press the release lever to secure the card to the sled.
6 Close the sled.
7 Insert the sled into the MX chassis and turn on the system and any attached MX chassis peripherals.
20
Deploying Dell HBA cards