Users Guide

a Press down and hold the metal tab on the SAS cable connector.
b Pull the SAS cable out of the connector.
7 If applicable, replace the storage controller card and connect the cable. For more information on installing the card, see Installing the
HBA330 adapter card
.
8 Close the system.
9 Reconnect the system to its electrical outlet and turn the system on, including any attached peripherals.
Figure 9. Removing and installing the HBA330 card
1
HBA330 adapter card 2 SAS cables (2)
3 SAS cable connectors (2) 4 card connector on the system board
5 HBA330 adapter card connector
Installing the HBA330 adapter card
CAUTION
: Many repairs may only be done by a certied service technician. You should only perform troubleshooting and simple
repairs as authorized in your product documentation, or as directed by the online or telephone service and support team.
Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that are shipped with your product.
1 Turn o the system, including any attached peripherals, and disconnect the system from the electrical outlet.
NOTE
: It is recommended that you always use a static mat and static strap while working on components in the interior of
the system.
2 Open the system.
3 Align the HBA card connector with the card connector on the system board and push the HBA card towards the connector to seat it
rmly.
4 Tighten the screws on the bracket, if any, or use the system’s retention clips to secure the controller on the system.
5 Connect the SAS data cable connectors to the card.
NOTE
: Ensure that you connect the cable according to the connector labels on the cable. The cable does not function
properly if reversed.
18 Deploying Dell HBA cards