Users Guide
Table Of Contents
- Dell Display Manager User's Guide
- Overview
- Using the Quick Settings Dialog
- About Your Monitor
- Setting Up the Monitor
- Operating the Monitor
- Troubleshooting
- Appendix
- Setting Up Your Monitor
- Setting the display resolution to 1920 x 1080 (Maximum)
- If you have a Dell desktop or a Dell portable computer with Internet access
- If you have a non Dell desktop, portable computer, or graphics card
- Procedures for setting up dual monitors in Windows Vista , Windows 7, Windows 8/Windows 8.1 or Windows 10
- Overview
Operating the Monitor 45
When the monitor enters the Power Save mode, the following message
appears:
Dell P2714H
Entering Power Save Mode.
Activate the computer and wake up the monitor to gain access to the
Using the On-Screen Display (OSD) Menu.
If you press any button other than the power button, the following
messages will appear depending on the selected input:
Dell P2714H
There is no signal coming from your computer. Press any key on the
keyboard or move the mouse to wake it up. If there is no display, press
the monitor button now to select the correct input source on the
On-Screen-Display menu.
If VGA, DVI or DisplayPort cable is not connected, a floating dialog box as
shown below appears. The monitor will enter Power Save Mode after 5
minutes if left at this state.
Dell P2714H
The dispaly will go into Power Save Mode in 5 minutes
No VGA Cable
?
www.dell.com/support/monitors