Users Guide

50 | Operating the Monitor
When the monitor enters the Standby mode, the following message will appear:
Dell 2X Monitor
Going into Standby mode…
P2X19HC
Activate the computer and wake up the monitor to gain access to the OSD.
Select OSD items of On in Standby Mode in Personalize feature, the following message
will appear:
Dell 2X Monitor
Changing to this setting (without symbol) will Increase
power consumption,Do you want to continue?
Yes No
P2X19HC
If adjust the Brightness level above the default level over 75%, the following message will
appear:
Dell 2X Monitor
Yes No
P2X19HC
Adjusting to this value will increase power consumption above the default level.
Do you want to continue?
If you press any button other than the power button, the following messages will appear
depending on the selected input:
No USB Type-C signal from your device.
Dell 2X Monitor
Press any key on the keyboard or move the mouse to wake it up.
If there is no display, press the monitor button again to select
the correct input source.
P2X19HC