Users Guide

46 | Operating the Monitor
When the monitor enters the Power Save mode, the following message appears:
Dell UltraSharp 24/27 Monitor
Entering Power Save Mode.
U2419HC/U2719DC
Activate the computer and wake up the monitor to gain access to the OSD.
If you press any button other than the power button, the following messages will appear
depending on the selected input:
Dell UltraSharp 24/27 Monitor
U2419HC/U2719DC
No DP signal from your device.
Press any key on the keyboard or move the mouse or wake it up.
If there is no display, press the monitor button again to select the correct
input source.
If either DP, USB Type-C input is selected and the corresponding cable is not connected, a
floating dialog box as shown below appears.
Dell UltraSharp 24/27 Monitor
The display will go into Power Save Mode in 4 minutes.
No DP Cable
www.dell.com/support/U2419HC
www.dell.com/support/U2719DC
U2419HC/U2719DC
or
Dell UltraSharp 24/27 Monitor
The display will go into Power Save Mode in 4 minutes.
No USB Type-C Cable
www.dell.com/support/U2419HC
www.dell.com/support/U2719DC
U2419HC/U2719DC