Users Guide

50 │ Operating your monitor
When the monitor enters the Power Save Mode, the following message appears:
Dell P2418HZ
Dell 20 Monitor
Entering Power Save Mode.
P2018H
If you press any button other than the power button, the following messages will
appear depending on the selected input:
Dell P2418HZ
Dell 20 Monitor
P2018H
Press any key on the keyboard or move the mouse to wake it up.
If there is no display, press the monitor button again to select
the correct input source.
?
No HDMI signal from your device.
If VGA, HDMI or DP cable is not connected, a floating dialog box as shown below
appears. The monitor will enter Power Save Mode after 4 minutes if left at this
state.
Dell P2418HZ
Dell P2018H
No VGA Cable
The display will go into Power Save Mode in 4 minutes.
www.dell.com/support/monitors
?
P2018H
or