Users Guide

reload-type fastboot
Restart the system with optimized booting-time functionality enabled. When you restart the device in fast boot mode, traffic
disruption is reduced significantly and the system operations to service the data traffic are restored in a seamless way.
C9000 Series
Syntax
reload-type fastboot
Parameters
fastboot Enable the system to restart the next time with the optimized booting-time
capability
Defaults By default, the device reloads in Jumpstart or BMP mode.
Command Modes GLOBAL CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S6100–ON.
9.8(1.0) Introduced on the Z9100–ON.
9.3(0.0) Added support for the fastboot parameter for S6000 platform.
Usage
Information
You can configure an optimization technique to reduce the booting time of an S6000 Switch. This
mechanism is also called fast boot. With the reduced time that is taken to reboot the switch, upon a
manually-initiated reload or an expected restart of the device, the disruption in traffic that is serviced by
the switch is minimized. Traffic outage is lowered considerably (reduced to approximately 25 seconds in
certain network deployments) when you enable this optimization method for booting of the device. By
reducing the duration of traffic loss, subscriber sessions are processed and preserved in an effective and
seamless way.
lacp fast-switchover
Cause the physical ports to be aggregated faster by configuring this capability in a port-channel on both the nodes that are
members of a port-channel.
Syntax
lacp fast-switchover
To disable the capability of faster aggregation of the member ports of a LAG or a port-channel bundle,
use the no version of this command.
Defaults Not configured
Command Modes INTERFACE (conf-if-po-number)
Command
History
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S6100–ON.
9.8(1.0) Introduced on the Z9100–ON.
9.3(0.0) Introduced on the S6000.
9.2(1.0) Introduced on the Z9500.
Flex Hash and Optimized Boot-Up 583