Service Manual

To determine which physical interfaces are available, use the show running-config command in EXEC mode. This
command displays all physical interfaces available on the system.
DellEMC#show running-config
[output truncated]
interface hundredGigE 1/1/1
no ip address
shutdown
!
interface hundredGigE 1/1/2
no ip address
shutdown
!
interface hundredGigE 1/1/3
no ip address
shutdown
!
interface hundredGigE 1/1/4
no ip address
shutdown
Resetting an Interface to its Factory Default State
You can reset the configurations applied on an interface to its factory default state. To reset the configuration, perform the
following steps:
1. View the configurations applied on an interface.
INTERFACE mode
show config
DellEMC(conf-if-te-1/1/5/1)#show config
!
interface TenGigabitEthernet 1/1/5/1
no ip address
portmode hybrid
switchport
rate-interval 8
mac learning-limit 10 no-station-move
no shutdown
2. Reset an interface to its factory default state.
CONFIGURATION mode
default interface interface-type]
DellEMC(conf)#default interface tengigabitethernet 1/1/5/1
3. Verify the configuration.
INTERFACE mode
show config
DellEMC(conf-if-te-1/1/5/1)#show config
!
interface TenGigabitEthernet 1/1/5/1
no ip address
shutdown
All the applied configurations are removed and the interface is set to the factory default state.
374
Interfaces