Release Notes
Table Of Contents
- Dell EMC Z9100–ON System Release Notes, OS Version 9.14(2.9P1)
- Document Revision History
- Requirements
- New Dell Networking OS Version 9.14(2.9) Features
- Restrictions
- Documentation Corrections
- Changes to the Default Behavior and CLI Syntax
- Deferred Issues
- Fixed Issues
- Known Issues
- Upgrading the sub-components
- Upgrading the ONIE Package for the Z9100-ON System
- Upgrading the DIAG Package for the Z9100-ON System
- Installing Dell EMC Networking OS on the Z9100-ON using ONIE
- Upgrading the Z9100-ON Dell EMC Networking OS Image using Dell EMC Networking OS CLI
- Uninstalling the Dell EMC Networking operating system
- Installing a Third Party Operating System
- Support Resources
Requirements
The following requirements apply to the Z9100-ON system.
Hardware Requirements
The following lists the Dell EMC Z9100-ON system hardware requirements:
● 10/25/40/50/100 GbE switch
●
Thirty two fixed quad form-factor pluggable (QSFP28) optical ports
● One each 10/100/100BaseT Ethernet management port, micro universal serial bus (MicroUSB-B) 2.0 console port, USB type
A port, and RS-232/RJ45 serial console port
● Two small form-factor pluggable plus (SFP+) 1000M/10G ports
● Two AC or DC power supplies units (PSUs) and five fan subsystem with airflow from the I/O side to the power supply unit
(PSU) side or from the PSU side to the I/O side
The following lists the individual Dell Z9100-ON system hardware components that are available to order:
● Fan with airflow from I/O side to PSU side
● Fan with airflow from PSU side to I/O side
● AC or DC power supply with airflow from I/O side to PSU side
●
AC or DC power supply with airflow from PSU side to I/O side
NOTE: Fan modules and power supplies are field replaceable units.
NOTE: All fans and PSUs must have the same airflow direction. If you mix the airflow direction, the switch detects the
discrepancy, issues an alarm, and may auto-shutdown to avoid heat damage to components. You must correct the mixed
airflow direction.
Software Requirements
Table 2. Software Requirements
Software Minimum Release Requirement
Dell EMC Networking OS 9.14(2.9)
ONIE 3.23.1.0-7
DIAG Installer 3.23.3.0-4
EDA Diags 3.23.4.1
NOTE: For information about non-Dell OS versions, see Dell EMC Z9100-Open Networking (ON) System Release Notes.
New Dell Networking OS Version 9.14(2.9) Features
The following features are integrated into the Dell EMC Networking 9.14.2 branch through this release:
None.
Restrictions
● Prerequisite steps to upgrade the Dell EMC Networking OS from earlier version to 9.14.2.0 or later:
1. Uninstall the older version of the Open Automation (OA) package
2. Upgrade the Dell EMC Networking OS to 9.14.2.0 or later version
3. Install the following OA packages from the respective upgraded version:
a. SmartScripts
2