Release Notes
Table Of Contents
- Dell EMC Z9100–ON System Release Notes, OS Version 9.14(2.9P1)
- Document Revision History
- Requirements
- New Dell Networking OS Version 9.14(2.9) Features
- Restrictions
- Documentation Corrections
- Changes to the Default Behavior and CLI Syntax
- Deferred Issues
- Fixed Issues
- Known Issues
- Upgrading the sub-components
- Upgrading the ONIE Package for the Z9100-ON System
- Upgrading the DIAG Package for the Z9100-ON System
- Installing Dell EMC Networking OS on the Z9100-ON using ONIE
- Upgrading the Z9100-ON Dell EMC Networking OS Image using Dell EMC Networking OS CLI
- Uninstalling the Dell EMC Networking operating system
- Installing a Third Party Operating System
- Support Resources
DellEMC#
NOTE: Do not power off the system while the FPGA upgrade is in progress. For any queries, contact Technical Support.
Upgrade the SmartFusion Microcontroller Subsystem — SMF MSS-
FPGA
NOTE: Before upgrading the SmartFusion Microcontroller Subsystem SMF MSS-FPGA, you must first upgrade the SMF
MSS-IAP.
To upgrade the SmartFusion Microcontroller Subsystem — SMF MSS-FPGA, follow these steps:
1. Upgrade the SMF MSS-FPGA image.
EXEC Privilege Mode
upgrade mss-fpga-image stack-unit <stack–unit–id> booted
DellEMC#upgrade mss-fpga-image stack-unit 1 booted
Current information for the system:
========================================================================
Card Device Name Current Version New Version
------------------------------------------------------------------------
CP Z9100-ON MSS FPGA 2.1 2.2
***********************************************************************
* Warning - Upgrading FPGA is inherently risky and should *
* only be attempted when necessary. A failure at this upgrade may *
* cause a board RMA. Proceed with caution ! *
***********************************************************************
Upgrade image for stack-unit 1 [yes/no]: yes
SMF FPGA upgrade in progress!!! Please do NOT power off the unit!!! Auto Reset will
happen at the end of Upgrade!!!
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
!!!!!!!!!!!!!!!!!!!!!!!!!!
Upgrade result :
================
UNIT1 SMF FPGA upgrade successful UNIT1. will go for reboot to complete the upgrade.
DellEMC#Dec 15 16:31:15: %STKUNIT1-M:CP %DOWNLOAD-6-FPGA_UPGRADE: UNIT 1 fpga upgrade
success.
NOTE:
Upgrade takes approximately five minutes and the system may appear unresponsive or powered off. During this
time, if you remove power from the system, you might need to return the unit to Dell for repair. For any queries, contact
Technical Support.
2. After the system re-boots, wait for the Dell prompt. Verify the MSS FPGA version using the show revision command
output.
EXEC Privilege Mode
show revision
DellEMC#show revision
-- Stack unit 1 --
Z9100-ON CPLD 1 : 7
Z9100-ON CPLD 2 : 4
Z9100-ON CPLD 3 : 4
15