Reference Guide

Dell EMC Networking OS withdraws the route. The route is re-installed, by Dell EMC Networking OS,
when the recursive resolution is satisfied.
After an IPv6 static route interface is created, if an IP address is not assigned to a peer interface, the
peer must be manually pinged to resolve the neighbor information.
You can specify a weight for an IPv4 or IPv6 static route. If the weight value of a path is 0, then that
path is not used for forwarding when weighted ECMP is in effect. Also, if a path corresponding to a
static route (destination) has a non-zero weight assigned to it and other paths do not have any weight
configured, then regular ECMP is used for forwarding.
You can specify the weight value only to destination address and not on the egress port.
A route is considered for weighted ECMP calculations only if each paths corresponding to that route is
configured with a weight.
Example
DellEMC(conf)# ipv6 route 44::/64 33::1 weight 100
DellEMC(conf)# ipv6 route 44::/64 33::2 weight 200
DellEMC(conf)# do show running-config | grep ipv6 route
DellEMC(conf)# ipv6 route vrf vrf_test 44::/64 33::1 weight 100
DellEMC(conf)# ipv6 route vrf vrf_test 44::/64 33::2 weight 200
DellEMC(conf)# do show running-config | grep ipv6 route vrf
Related
Commands
● show ipv6 route — view the IPv6 configured routes.
show ipv6 management-route
Display the IPv6 static routes configured for the management interface.
Syntax
show ipv6 management-route [all | connected | summary | static]
Parameters
all (OPTIONAL) Enter the keyword all to view all IP addresses assigned to all
Management interfaces on the switch.
connected (OPTIONAL) Enter the keyword connected to view only routes directly
connected to the Management interface.
summary (OPTIONAL) Enter the keyword summary to view a table listing the number of
active and non-active routes and their sources.
static (OPTIONAL) Enter the keyword static to view non-active routes also.
Command Modes EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100–ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
778 IPv6 Basics