Reference Guide

Usage
Information
You can configure the optimal switchover functionality for LACP even if you do not enable the fast boot
mode on the system. You must configure the long timeout mechanism for the LACP session to enable the
fast boot capability to operate properly. This command applies to dynamic port-channel interfaces only.
When applied on a static port-channel, this command has no effect
If you configure the optimized booting-time capability and perform a reload of the system, the LACP
application sends PDUs across all the active LACP links immediately.
Related
Commands
show lacp — displays the LACP configuration.
encapsulation dot1q
Configures lite-subinterfaces.
Syntax
encapsulation dot1q vlan-id
To remove a previously configured lite-subinterface, use the no encapsulation dot1q vlan-id
command.
Parameters
dot1q vlan-id Enter the keyword dot1q followed by the VLAN ID to which the host belongs. The
range is from 1 to 4094. A lite subinterface is considered as a Layer 3 port property
and is synchronous with the existing rules of applying Layer 2 or Layer 3 properties
to an interface.
Command Modes
INTERFACE
Command
History
Version Description
9.12.1.0 Introduced on the S5048F–ON.
9.10(0.1) Introduced on the S6010-ON and S4048-ON.
9.10(0.0) Introduced on the S6100–ON.
9.8(1.0) Introduced on the Z9100–ON.
9.3.0.0 Introduced on the S6000.
9.2(1.0) Introduced on the Z9500.
Usage
Information
To enable routing of RRoCE packets, the VLAN ID is mapped to the default VLAN ID of 4095 and this
mapping is performed using VLAN translation. After VLAN translation, the RRoCE packets are considered
in the same manner as normal IP packets that received on L3 interface and routed in the egress direction.
At the egress interface, the VLAN ID is appended to the packet and transmitted out of the interface as
a tagged packet with the dot1Q value preserved. The dot1Q value is preserved only for egress interfaces
that are associated with a VLAN or a lite-subinterface . If a Layer 3 interface is configured without the
encapsulation 802.1Q VLAN ID or is an untagged interface in a VLAN , the dot1Q value is not preserved .
Flex Hash and Optimized Boot-Up 571