Reference Guide

Usage
Information
You can use the redistribute command to advertise the IGP cost as the MED on redistributed routes.
When you set the route-map with metric-type internal and apply outbound to an EBGP peer/peer-group,
the advertised routes corresponding to those peer/peer-groups have the IGP cost set as MED.
When you enter the redistribute isis process-id command without any other parameters, Dell
EMC Networking OS redistributes all OSPF internal routes, external type 1 routes, and external type 2
routes. RFC does not support this feature.
router bgp
To configure and enable BGP, enter ROUTER BGP mode.
Syntax
router bgp as-number
To disable BGP, use the no router bgp as-number command.
Parameters
as-number Enter the AS number. The range is from 1 to 65535 (2 byte), from 1 to 4294967295
(4 byte), or from 0.1 to 65535.65535 (dotted format).
Defaults Not enabled.
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100-ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
Usage
Information
At least one interface must be in Layer 3 mode for the router bgp command to be accepted. If all
interfaces are configured under VRF, at least one interface should be in the default VRF for the router
bgp command to be accepted. If no interfaces are enabled for Layer 3, an error message appears:
% Error: No router id
configured
BGP does not allow 23456 (AS-TRANS) as a configured AS number.
Example
DellEMC(conf)# router bgp 3
DellEMC(conf-router_bgp)#
396 Border Gateway Protocol