Reference Guide

Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.8(0.0) Added the no-drop parameter.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.3.1.0 Added the keyword dscp.
8.2.1.0 Allows ACL control of fragmented packets for IP (Layer 3) ACLs.
8.1.1.0 Introduced on the E-Series.
7.4.1.0 Added support for non-contiguous mask and added the monitor option.
6.5.1.0 Expanded to include the optional QoS order priority for the ACL entry.
Usage
Information
The order option is relevant in the context of the Policy QoS feature only. For more information, see the
Quality of Service section of the Dell EMC Networking OS Configuration Guide.
The monitor option is relevant in the context of flow-based monitoring only. For more information, see
Port Monitoring .
deny tcp
Configure a filter that drops transmission control protocol (TCP) packets meeting the filter criteria.
Syntax
deny tcp {source mask | any | host ip-address} [bit] [operator port [port]]
{destination mask | any | host ip-address} [ttl operator] [dscp] [bit]
[operator port [port]] [count [bytes] [order] [fragments] [monitor] [no-
drop]
To remove this filter, you have two choices:
● Use the no seq sequence-number command if you know the filter’s sequence number.
● Use the no deny tcp {source mask | any | host ip-address} {destination mask
| any | host ip-address} command.
Parameters
source Enter the IP address of the network or host from which the packets are sent.
mask Enter a network mask in /prefix format (/x) or A.B.C.D. The mask, when specified
in A.B.C.D format, may be either contiguous or non-contiguous.
any Enter the keyword any to specify that all routes are subject to the filter.
host ip-address Enter the keyword host then the IP address to specify a host IP address.
ttl Enter the keyword ttl to deny a packet based on the time to live value. The range
is from 1 to 255.
operator Enter one of the following logical operand:
● eq(equal to) — matches packets that contain a ttl value that is equal to the
specified ttl value.
● neq(not equal to) — matches packets that contain a ttl value that is not equal
to the specified ttl value.
● gt(greater than) — matches packets that contain a ttl value that is greater
than the specified ttl value.
192 Access Control Lists (ACL)