Reference Guide

parameter-problem count
time-exceeded count
port-unreachable count
The ICMP packets cannot be filtered using mirroring ACL.
ttl Enter the keyword ttl to deny a packet based on the time to live value. The range
is from 1 to 255.
operator Enter one of the following logical operand:
● eq(equal to) — matches packets that contain a ttl value that is equal to the
specified ttl value.
● neq(not equal to) — matches packets that contain a ttl value that is not equal
to the specified ttl value.
● gt(greater than) — matches packets that contain a ttl value that is greater
than the specified ttl value.
● lt (less than) — matches packets that contain a ttl value that is less than the
specified ttl value.
● range(inclusive range of values) — matches packets that contain a ttl value
that falls between the specified range of ttl values.
dscp Enter this keyword dscp to deny a packet based on the DSCP value. The range is
from 0 to 63.
count (OPTIONAL) Enter the keyword count to count packets processed by the filter.
byte (OPTIONAL) Enter the keyword byte to count bytes processed by the filter.
order (OPTIONAL) Enter the keyword order to specify the QoS priority for the ACL
entry. The range is from 0 to 254 (where 0 is the highest priority and 254 is the
lowest; lower order numbers have a higher priority) If you did not use the keyword
order, the ACLs have the lowest order by default (255).
fragments Enter the keyword fragments to use ACLs to control packet fragments.
monitor (OPTIONAL) Enter the keyword monitor to describe the traffic that you want to
monitor and the ACL in which you are creating the rule is applied to the monitored
interface. For more information, see Flow-based Monitoring in the Port Monitoring
section in the Dell EMC Networking OS Configuration Guide.
no-drop Enter the keywords no-drop to match only the forwarded packets.
Defaults Not configured.
Command Modes CONFIGURATION-EXTENDED-ACCESS-LIST
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.12(0.0) Introduced the ttl parameter. Removed the session–ID option from the monitor
parameter.
9.11(2.0P0) Added the type parameter to filter the ICMP packets based on the type and code
on the S6000, S6000–ON, S6100–ON, Z9100–ON.
9.11(0.0) Added support for session–ID to the monitor parameter.
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100-ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
Access Control Lists (ACL) 191