API Guide

Match only packets on a
given port number
fin
Match on the fin bit
gt
Match only packets with a
greater port number
lt
Match only packets with a
lower port number
neq
Match only packets not on a
given port number
psh
Match on the psh bit
range
Match only packets in the
range of port numbers
rst
Match on the rst bit
syn
Match on the syn bit
urg
Match on the urg bit
cr
Dell(conf-redirect-
list)#redirect 1.1.1.1 udp
any any ?
eq
Match only packets on a
given port number
gt
Match only packets with a
greater port number
lt
Match only packets with a
lower port number
neq
Match only packets not on a
given port number
range
Match only packets in the
range of port numbers
Delete a rule with the
no redirect command.
The redirect rule supports Non-contiguous bitmasks for PBR in the Destination router IP
address
Creating a Rule Example:
The below step shows a step-by-step example of how to create a rule for a redirect list by configuring:
• IP address of the next-hop router in the forwarding route
• IP protocol number
• Source address with mask information
• Destination address with mask information
Dell(conf-redirect-list)#redirect ?
A.B.C.D Forwarding router's address
Dell(conf-redirect-list)#redirect 3.3.3.3 ?
<0-255> An IP protocol number
icmp Internet Control Message Protocol
ip Any Internet Protocol
tcp Transmission Control Protocol
udp User Datagram Protocol
Dell(conf-redirect-list)#redirect 3.3.3.3 ip ?
658
Policy-based Routing (PBR)