White Papers

Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.8(2.0) Introduced on the S3100 series.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.2.1.0 Introduced command.
7.7.1.0 Introduced on the C-Series.
Usage
Information
Any update without a MED attribute is the least preferred route.
If you enable this command, use the clear ip bgp * command to recompute the best path.
bgp add-path
Allow the advertisement of multiple paths for the same address prefix without the new paths replacing any previous ones.
Syntax
bgp add-path [send | receive | both | enable] path-count
Parameters
send Enter the keyword send to indicate that the system sends multiple paths to peers.
receive Enter the keyword receive to indicate that the system accepts multiple paths
from peers.
both Enter the keyword both to indicate that the system sends and accepts multiple
paths from peers.
enable Enter the keyword enable to enable add-path support support for the node.
path-count Enter the number paths supported. The range is from 2 to 64.
Defaults Disabled
Command Modes
● ROUTER BGP
● ROUTER BGP-address-family
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.8(2.0) Introduced on the S3100 series.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
Border Gateway Protocol 341