White Papers

Parameters
interface (OPTIONAL) Enter the following keywords and the interface information:
● For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
● For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the
slot/port information.
● For a VLAN interface, enter the keyword vlan, and then the VLAN ID. The
VLAN ID range is from 1 to 4094.
priority-cost (OPTIONAL) Enter a number as the amount to subtract from the priority value. The
range is from 1 to 254. The default is 10.
Defaults priority cost = 10
Command Modes VRRP
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100–ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
7.6.1.0 Introduced on the S-Series (S50 only).
7.5.1.0 Introduced on the C-Series.
6.2.1.1 Introduced on the E-Series.
Usage
Information
If you disable the interface, the cost value is subtracted from the priority value and forces a new MASTER
election if the priority value is lower than the priority value in the BACKUP virtual routers.
version
Set the VRRP protocol version for the IPv4 group.
Syntax
version {2 | 3 | both}
To return to the default setting, use the no version command.
Parameters
2 Enter the keyword 2 to specify VRRP version 2 as defined by RFC 3768, Virtual
Router Redundancy Protocol.
3 Enter the keyword 3 to specify VRRP version 3 as defined by RFC 5798, Virtual
Router Redundancy Protocol.
both Enter the keyword both for in-service migration from VRRP version 2 to VRRP
version 3.
Defaults 2
Command Modes VRRP
Virtual Router Redundancy Protocol (VRRP) 1727