White Papers

Version Description
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
E-Series legacy
command
Usage
Information
The oid-tree variable is a full sub-tree starting from 1.3.6 and cannot specify the name of a sub-tree
or a MIB. The following Example configures a view named rview that allows access to all objects under
1.3.6.1.
Example
DellEMC# conf
DellEMC#(conf) snmp-server view rview 1.3.6.1 included
Related
Commands
● show running-config snmp — displays the SNMP running configuration.
snmp trap link-status
Enable the interface to send SNMP link traps, which indicate whether the interface is up or down.
Syntax
snmp trap link-status
To disable sending link trap messages, use the no snmp trap link-status command.
Defaults Enabled.
Command Modes INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S6100–ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
9.2(0.0) Introduced on the M I/O Aggregator. This command is supported in Programmable-
Mux (PMUX) mode only.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
Simple Network Management Protocol (SNMP) and Syslog 1529