White Papers

Usage
Information
You must have an IP address assigned to an interface to enter ROUTER OSPF mode and configure OSPF.
You can create only one OSPFv2 process per VRF.
After the OSPF process and the VRF are tied together, you cannot use the OSPF Process ID again in the
system.
Example
DellEMC(conf)# router ospf 2
DellEMC(conf-router_ospf)#
show config
Display the non-default values in the current OSPF configuration.
S4820T
Syntax
show config
Command Modes ROUTER OSPF
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100-ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre- 6.1.1.1 Introduced on the E-Series.
Example
DellEMC(conf-router_ospf)# show config
!
router ospf 3
passive-interface 0 TenGigabitEthernet 1/1
DellEMC(conf-router_ospf)#
1140 Open Shortest Path First (OSPFv2 and OSPFv3)