White Papers

ip ftp vrf
Configures an FTP client with a VRF that is used to connect to the FTP server.
Syntax
ip ftp [vrf {vrf-name | management}]
To undo the FTP client configuration, use the ip ftp [vrf vrf-name] command.
Parameters
vrf-name Enter the vrf-name to specify the VRF that is used by the FTP client.
management Enter the keyword management to specify that the VRF used by the FTP client is
a management VRF.
Defaults Disabled
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100-ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.5(0.0) Introduced on the Z9500.
9.4(0.0) Introduced on the S-Series and Z9000.
Usage
Information
Use this command to make the FTP clients VRF-aware. The VRF name that you specify is used by the
FTP client to reach the FTP server. If no VRF name is specified, then the default VRF is used.
ip ftp source-interface
Specify an interface’s IP address as the source IP address for FTP connections.
Syntax
ip ftp source-interface interface
To delete an interface, use the no ip ftp source-interface interface command.
Parameters
interface Enter the following keywords and the interface information:
● For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
● For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the
slot/port information.
● For a Loopback interface, enter the keyword loopback then a number from 0
to 16383.
● For a port-channel interface, enter the keywords port-channel then the
port-channel ID.
● For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
● For a tunnel interface, enter the keyword tunnel.
Defaults The IP address on the system that is closest to the Telnet address is used in the outgoing packets.
Control and Monitoring 109