Deployment Guide

7 0001111100000000 1111111111000000 7936 7999 64
8 0001111101000000 1111111111111111 8000 8000 1
Total Ports: 4001
Example
An ACL rule with TCP port lt 1023 takes only one entry in the CAM:
Rule# Data Mask From To #Covered
1 0000000000000000 1111110000000000 0 1023 1024
Total Ports: 1024
Related
Commands
deny – assigns a filter to deny IP traffic.
deny tcp – assigns a deny filter for TCP traffic.
ipv6 access-list
Configure an access list based on IPv6 addresses or protocols.
Syntax
ipv6 access-list access-list-name cpu-qos
To delete an access list, use the no ipv6 access-list access-list-name command.
Parameters
access-list-name Enter the access list name as a string, up to 140 characters.
cpu-qos Enter the keyword cpu-qos to assign this ACL to control plane traffic only
(CoPP).
permit Enter the keyword permit to configure a filter to forward packets meeting this
condition.
deny Enter the keyword deny to configure a filter to drop packets meeting this
condition.
ospfv3 Specify that this ACL is for OSPFv3 control plane traffic
Defaults All access lists contain an implicit “deny any”; that is, if no match occurs, the packet is dropped.
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100–ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.4(0.0) Added support for CoPP for OSPFv3 on the S4810, S4820T, S6000, and Z9000
platforms.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000
228 Access Control Lists (ACL)