Deployment Guide

Example
DellEMC# show ipv6 ospf 3 neighbor te 1/1/2/1
Neighbor ID Pri State Dead Time Interface ID Interface
63.114.8.36 1 FULL/DR 00:00:38 4 Te 1/1/2/1
DellEMC#
snmp context
Configure SNMPv3 context name to map multiple OSPFv3 VRF instances.
Syntax
snmp context {context-name}
To clear snmp context, use the no snmp context {context-name} command.
Parameters
context-name Enter the SNMP context name. The maximum length is 32 alphanumeric
characters.
Defaults None.
Command Modes IPv6 ROUTER OSPF
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.14(1.0) Introduced on the S3100 series, S3048–ON, S4048–ON, S4048T-ON, S5048F-ON,
S6000, S6010–ON, S6100–ON, Z9100–ON, Z9500, S6000–ON, C9010, MXL, and
FN IOM.
Usage
Information
Use SNMPv3 context configuration to distinguish between various OSPFv3 VRF instances.
Example
DellEMC(conf-ipv6-router_ospf)#snmp context ospf1
DellEMC>show runnig-config ospf
!
ipv6 router ospf 10
router-id 10.10.10.1
snmp context ospf1
!
DellEMC>
timers spf
Set the time interval between when the switch receives a topology change and starts a shortest path first (SPF) calculation.
Syntax
timers spf delay holdtime msec
To return to the default, use the no timers spf command.
Parameters
delay Enter a number as the delay. The range is from 0 to 2147483647. The default is 5
seconds. When configured in milli seconds, 100 is the least value that is allowed to
be configured.
1154 Open Shortest Path First (OSPFv2 and OSPFv3)