Setup Guide

enable stack-unit transceiver
Enable the 10GBase-T optical port that is reset due to high temperature to normal mode.
Syntax
enable stack-unit unit-number port port-number transceiver
Parameters
stack-unit unit-
number
Enter the keyword stack-unit then the unit-number for which you want to
enable temperature polling. The range is from 1 to 6.
port port-number Enter the keyword port then the port-number for which you want to enable
temperature polling. The range is from 1 to 48.
Defaults Enabled
Command Modes EXEC
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.14(0.0) Introduced on the S4048–ON and S5048F-ON.
Usage
Information
This feature is applicable only for 10GBase-T optical ports.
NOTE: It is not supported for stacking ports.
encapsulation dot1q
Configures lite-subinterfaces.
Syntax
encapsulation dot1q vlan-id
To remove a previously configured lite-subinterface, use the no encapsulation dot1q vlan-id
command.
Parameters
dot1q vlan-id Enter the keyword dot1q followed by the VLAN ID to which the host belongs. The
range is from 1 to 4094. A lite subinterface is considered as a Layer 3 port property
and is synchronous with the existing rules of applying Layer 2 or Layer 3 properties
to an interface.
Command Modes
INTERFACE
Command
History
Version Description
9.12.1.0 Introduced on the S5048F–ON.
9.10(0.1) Introduced on the S6010-ON and S4048-ON.
9.10(0.0) Introduced on the S6100–ON.
9.8(1.0) Introduced on the Z9100–ON.
9.3.0.0 Introduced on the S6000.
9.2(1.0) Introduced on the Z9500.
Usage
Information
To enable routing of RRoCE packets, the VLAN ID is mapped to the default VLAN ID of 4095 and this
mapping is performed using VLAN translation. After VLAN translation, the RRoCE packets are considered
in the same manner as normal IP packets that received on L3 interface and routed in the egress direction.
At the egress interface, the VLAN ID is appended to the packet and transmitted out of the interface as
a tagged packet with the dot1Q value preserved. The dot1Q value is preserved only for egress interfaces
that are associated with a VLAN or a lite-subinterface . If a Layer 3 interface is configured without the
encapsulation 802.1Q VLAN ID or is an untagged interface in a VLAN , the dot1Q value is not preserved .
Interfaces 683