Release Notes

Unit1 S6000-ON MASTER CPLD 12 12
Unit1 S6000-ON SLAVE CPLD 10 10
***********************************************************************
* Warning - Upgrading FPGA is inherently risky and should *
* only be attempted when necessary. A failure at this upgrade may *
* cause a board RMA. Proceed with caution ! *
***********************************************************************
Upgrade image for stack-unit 1 [yes/no]:
2. Power cycle the system physically. Switch off the system by unplugging the power chords from the REAR PSUs and wait
until the PSU FAN–REAR STATUS LED is completely OFF.
NOTE: Do not switch on the system with PSU–REAR LED glowing AMBER.
3. Switch on the system and wait for the Dell prompt. The CPLD version can be verified using the show revision command.
EXEC Privilege Mode
show revision
Dell#show revision
-- Stack unit 1 --
S6000-ON SYSTEM CPLD : 10
S6000-ON MASTER CPLD : 12
S6000-ON SLAVE CPLD : 10
Dell#
NOTE:
Do not use power-cycle stack-unit command to power cycle the system and do not power off the system
while FPGA upgrade is in progress. For any queries, contact technical support.
Uninstalling Dell Networking OS from the S6000-ON
To uninstall the Dell Networking OS version 9.14(2.10) from the S6000-ON device, perform the following steps:
1. Reboot the system. During the reboot process, the system displays the following message prompting you to press the Esc
key in order to stop the auto-boot process:
Version 2.15.1236. Copyright (C) 2021 American Megatrends, Inc.
BIOS Date: 05/18/2021 21:34:20 Ver: 0ACAH019
Press DEL or F2 to enter setup.
Grub 1.99~rc1 (Dell Inc)
Built by root at ubuntu on Tue_May_18_14:04:19_UTC_2021
S6000ON Boot Flash Label 3.20.2.5 NetBoot Label 3.20.2.5
Press Esc to stop autoboot ... 5
2. At this prompt message, press the Esc key. The following menu appears:
+----------------------------------------------------------------------------+
| FTOS
| FTOS-Boot Line Interface
| ONIE
+----------------------------------------------------------------------------+
3. From the menu, choose the ONIE option.
NOTE:
To choose an option from the menu, highlight one of the options using the up or down arrow key and press
Enter.
The following menu appears:
+------------------------------------------------------------------+
| ONIE: Install OS |
| ONIE: Rescue |
|*ONIE: Uninstall OS |
| ONIE: Update ONIE |
12