Deployment Guide

The new cam region ipv6mirracl is introduced in the cam-acl command to configure dedicated FP CAM regions for the
IPv6 mirror ACL entries.
NOTE: If you do not enter the allocation values for the CAM regions, the value is 0.
3. Execute write memory and verify that the new settings are written to the CAM on the next boot.
EXEC Privilege mode
show cam-acl
4. Reload the system.
EXEC Privilege mode
reload
Test CAM Usage
To determine whether sufficient CAM space is available to enable a service-policy, use the test-cam-usage command. To
verify the actual CAM space required, create a Class Map with all required ACL rules, then execute the test cam-usage
command in Privilege mode. The Status column in the command output indicates whether or not you can enable the policy.
Example of the test cam-usage Command
DellEMC#test cam-usage service-policy input test-cam-usage stack-unit 1 po 0
Stack-Unit| Portpipe|CAM Partition|Available CAM|Estimated CAM per Port|Status
------------------------------------------------------------------------------------
2 | 0 |IPv4Flow |192 |3 |Allowed (64)
DellEMC#
View CAM Profiles
To view the current CAM profile for the chassis and each component, use the show cam-profile command.
This command also shows the profile that is loaded after the next chassis or component reload.
Example of the show cam-profile Command
Dell#show cam-profile
-- Chassis CAM Profile --
CamSize : 18-Meg
: Current Settings : Next Boot
Profile Name : Default : Default
L2FIB : 32K entries : 32K entries
L2ACL : 1K entries : 1K entries
IPv4FIB : 256K entries : 256K entries
IPv4ACL : 12K entries : 12K entries
IPv4Flow : 24K entries : 24K entries
EgL2ACL : 1K entries : 1K entries
EgIPv4ACL : 1K entries : 1K entries
Reserved : 8K entries : 8K entries
FIB : 0 entries : 0 entries
ACL : 0 entries : 0 entries
Flow : 0 entries : 0 entries
EgACL : 0 entries : 0 entries
MicroCode Name : Default : Default
--More--
To view brief output of the show cam-profile command, use the summary option.
The show running-config cam-profile command shows the current profile and microcode.
NOTE:
If you select the CAM profile from CONFIGURATION mode, the output of this command does not reflect any
changes until you save the running-configuration and reload the chassis.
Content Addressable Memory (CAM) 225