CLI Guide

LineSpeed auto
ARP type: ARPA, ARP Timeout 04:00:00
Last clearing of "show interface" counters 6d21h13m
Queueing strategy: fifo
Time since last interface status change: 6d21h13m
Related
Commands
● show interfaces configured – displays any interface with a non-default configuration.
● show interfaces switchport – displays Layer 2 information about the interfaces.
● show inventory (S-Series and Z-Series) – displays the S Series and Z-Series switch types,
components (including media), Dell Networking OS version including hardware identification numbers,
and configured protocols.
● show ip interface – displays Layer 3 information about the interfaces.
● show range – displays all interfaces configured using the interface range command.
show interfaces configured
Display any interface with a non-default configuration.
C9000 Series
Syntax
show interfaces configured
Command Modes
● EXEC
● EXEC Privilege
Command
History
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.4.1.0 Changed the organization of the display output.
Dell#show interfaces configured | no-more
TenGigabitEthernet 6/0 is up, line protocol is down
Hardware is DellEth, address is 34:17:eb:00:20:93
Current address is 34:17:eb:00:20:93
Pluggable media present, SFP+ type is 10GBASE-SR
Medium is MultiRate, Wavelength is 850nm
SFP+ receive power reading is -2.0350dBm
Interface index is 7340036
Interface mode is Cascade
Internet address is not set
Mode of IPv4 Address Assignment : NONE
DHCP Client-ID :3417eb002093
MTU 16364 bytes, IP MTU 16346 bytes
LineSpeed auto
Flowcontrol rx off tx off
ARP type: ARPA, ARP Timeout 04:00:00
Last clearing of "show interface" counters 04:24:38
Queueing strategy: fifo
Input Statistics:
Interfaces 751