CLI Guide

● The VLAN cannot belong to an ACL VLAN group.
If you apply a MAC ACL on a physical or port-channel interface, a VLAN to which the port is associated
cannot have another ACL applied.
If you apply a MAC ACL on an ACL VLAN group, none of the VLANs in the group can have another ACL
applied.
Related
Commands
mac access-list standard — configures a standard MAC ACL.
mac access-list extended — configures an extended MAC ACL.
show mac access-lists
Display all of the Layer 2 ACLs configured in the system, whether or not they are applied to an interface, and the count of
matches/mismatches against each ACL entry displayed.
C9000 Series
Syntax
show mac access-lists [acl_name word | interface } {in | out | interface}
Parameters
access-list Displays information on all L2 access-lists configured.
acl_name word Enter the acl_name word , up to 140 characters, for specified access-list.
interface
interface
Enter the keyword interface then the one of the following keywords and slot/
port or number information:
● For a Port Channel interface, enter the keyword port-channel and then
enter a number. The C-Series and S-Series range is from 1 to 4096.
● For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet and then enter the slot/port information.
● For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE and then
enter the slot/port information.
● For a VLAN interface, enter the keyword VLAN followed by the vlan id.
● For a PE Gigabit Ethernet interface, enter the keyword peGigE then the pe-id/
stack-unit/ port-id information.
● For a port extender 10-Gigabit Ethernet interface, enter the keyword
peTenGigE then the pe-id / stack-unit / port-id information. The pe-id range
is from 0 to 255; the stack-unit unit-number range is from 0 to 7; and the
port-id range is 25 to 28 or 49 to 52 depending on the PE.
in Display information of L2 ingress access-list configured to an interface.
out Display information of L2 egress access-list configured to an interface.
Command Modes EXEC
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.13.0.1P1 Introduced peTenGigE interface support on the C9010.
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
262 Access Control Lists (ACL)