CLI Guide

radius-server retransmit
Configure the number of times the switch attempts to connect with the configured RADIUS host server before declaring the
RADIUS host server unreachable.
C9000 Series
Syntax
radius-server retransmit retries
To configure zero retransmit attempts, use the no radius-server retransmit command.
To return to the default setting, use the radius-server retransmit 3 command.
Parameters
retries Enter a number of attempts that the system tries to locate a RADIUS server. The
range is from zero (0) to 100. The default is 3 retries.
Defaults 3 retries
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.2.1.0 Introduced on the E-Series.
Related
Commands
radius-server host — configures a RADIUS host.
radius-server timeout
To reply to a request, configure the amount of time the RADIUS client (the switch) waits for a RADIUS host server .
C9000 Series
Syntax
radius-server timeout seconds
To return to the default value, use the no radius-server timeout command.
Parameters
seconds Enter the number of seconds between an unsuccessful attempt and when the
system times out. The range is from zero (0) to 1000 seconds. The default is 5
seconds.
Defaults 5 seconds
Command Modes CONFIGURATION
Security 1535