CLI Guide

The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.2.1.0 Introduced on the E-Series.
port
Configures NAS port number to accept CoA or DM requests.
Syntax
port port-number
To remove the NAS port configuration, enter the no port command.
Defaults 3799
Parameters
port-number Enter the NAS port number to accept CoA and DM requests. The range is from 1 to
65535.
Command Modes
● CONF-DYNAMIC-AUTH
Usage
Information
● Optionally specify dynamic authorization port number. Default port is 3799.
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
The following is a list of the Dell EMC Networking OS version history for this command.
Version Description
9.13(0.0) Introduced on the C9010, S3100, S3048–ON, S4048T-ON, S4048–ON, S5000,
S6010–ON, S6000–ON, S6100–ON, S6000, Z9100–ON, Z9500, FN-IOM, and
MXL.
radius dynamic-auth
Enters a new sub-mode, RADIUS-DYNAMIC-AUTH, which enables you to modify dynamic authorization settings.
Syntax
radius dynamic-auth
To remove the dynamic authorization method for RADIUS users, enter the no radius dynamic-auth
command.
Defaults Disabled.
Command Modes
● CONFIGURATION
Usage
Information
● All dynamic authorization commands are configured by entering this mode.
Security 1531