CLI Guide

Version Description
9.13(0.0) Introduced on the C9010, S3100, S3048–ON, S4048T-ON, S4048–ON, S5000,
S6010–ON, S6000–ON, S6100–ON, S6000, Z9100–ON, Z9500, FN-IOM, and
MXL.
dynamic-auth-enable
Configure NAS to receive and process dynamic authorization messages.
Syntax
dynamic-auth-enable
To stop NAS from receiving and processing dynamic authorization messages, use the no dynamic-
auth-enable command.
Defaults Disabled.
Command Modes
● CONF-DYNAMIC-AUTH
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
The following is a list of the Dell EMC Networking OS version history for this command.
Version Description
9.13(0.0) Introduced on the C9010, S3100, S3048–ON, S4048T-ON, S4048–ON, S5000,
S6010–ON, S6000–ON, S6100–ON, S6000, Z9100–ON, Z9500, FN-IOM, and
MXL.
Usage
Information
If this configuration is not enabled, then dynamic authorization messages are not handled by the NAS.
ip radius source-interface
Specify an interface’s IP address as the source IP address for RADIUS connections.
C9000 Series
Syntax
ip radius source-interface interface
To delete a source interface, use the no ip radius source-interface command.
Parameters
interface Enter the following keywords and slot/port or number information:
● For Loopback interfaces, enter the keyword loopback then a number from
zero (0) to 16838.
● For the Null interface, enter the keywords null 0.
● For a Port Channel interface, enter the keywords port-channel then a
number. The range is from 1 to 128.
● For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
● For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the
slot/port information.
● For VLAN interface, enter the keyword vlan then a number from 1 to 4094.
Defaults Not configured.
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
1530 Security