White Papers

5 - -
6 - -
7 - -
8 - -
DCBX Commands
The following DCBX commands are supported on the Dell EMC Networking OS.
advertise dcbx-app-tlv
Configure DCBX to send iSCSI TLV advertisements.
S4810
Syntax
advertise dcbx-app-tlv iscsi
To disable DCBX iSCSI TLV advertisements, use the no advertise dcbx-app-tlv iscsi
command.
Defaults Enabled
Command Modes PROTOCOL LLDP
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.16.0 Introduced on MXL 10/40GbE Switch IO Module.
Usage
Information
You can configure iSCSI TLVs to send either globally or on a specified interface. The interface
configuration takes priority over global configuration.
advertise dcbx-appln-tlv
On a DCBX port with a manual role, configure the application priority TLVs advertised on the interface to DCBX peers.
Syntax
advertise dcbx-appln-tlv {fcoe | iscsi}
To remove the application priority TLVs, use the no advertise dcbx-appln-tlv {fcoe |
iscsi} command.
Parameters
{fcoe | iscsi} Enter the application priority TLVs, where:
● fcoe: enables the advertisement of FCoE in application priority TLVs.
● iscsi: enables the advertisement of iSCSI in application priority TLVs.
Defaults Application priority TLVs are enabled to advertise FCoE and iSCSI.
Command Modes PROTOCOL LLDP
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Data Center Bridging (DCB) 495