White Papers

Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S-Series.
Usage
Information
A new policy command is introduced in order to attach the Link Bandwidth extended community only
to the prefixes that are received from a neighbor that satisfy the desired conditions. This command is
relevant for both inbound as well as outbound policy handling (for received prefixes). Also, there is no
change to the set of supported conditions or filters.
During configuration, the bandwidth is specified in Mbps, not in bytes/second. While creating the actual
LB extended community, the system will attach the AS number and encode the bandwidth in floating
point format.
shutdown all
Disables all the BGP neighbors.
Syntax
shutdown all
Use the no shutdown all command to enable all the configured BGP neighbors.
Command Modes ROUTER BGP
Command
History
Version Description
9.11.0.0 Introduced on the S-Series, Z-Series, MXL, and IOM.
Usage
Information
You can use this command to disable all the configured BGP neighbors.
This command is global for all VRFs.
shutdown address-family-ipv4–multicast
Disables all the BGP neighbors corresponding to the multicast IPv4 address families.
Syntax
shutdown address-family-ipv4–unicast
Use the no shutdown address-family-ipv4–unicast command to enable all the configured
BGP neighbors corresponding to the multicast IPv4 address families.
Command Modes
ROUTER BGP
CONFIGURATION
Command
History
Version Description
9.11.0.0 Introduced on the S-Series, Z-Series, MXL, and IOM.
Usage
Information
You can use this command to disable all the configured BGP neighbors corresponding to the multicast
IPv4 address families.
This command is global for all VRFs.
410 Border Gateway Protocol