White Papers

Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100-ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
Usage
Information
At least one interface must be in Layer 3 mode for the router bgp command to be accepted. If all
interfaces are configured under VRF, at least one interface should be in the default VRF for the router
bgp command to be accepted. If no interfaces are enabled for Layer 3, an error message appears:
% Error: No router id
configured
BGP does not allow 23456 (AS-TRANS) as a configured AS number.
Example
DellEMC(conf)# router bgp 3
DellEMC(conf-router_bgp)#
set extcommunity bandwidth
Enables you to set extended community bandwidth.
Syntax
set extcommunity bandwidth
To disable extended community bandwidth, enter the no set extcommunity bandwidth command.
Parameters
bandwidth Enter the keyword bandwidth to enable extended community bandwidth. The
range is from 0 to 102400.
Defaults N/A
Command Modes ROUTER MAP
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100-ON.
Border Gateway Protocol 409