White Papers

ManualsBrandsDell ManualsAccess PlatformsOS9

1611

Table Of Contents

Version Description

9.8(2.0) Introduced on the S3100 series.

9.8(1.0) Introduced on the Z9100–ON.

9.8(0.0P5) Introduced on the S4048-ON.

9.8(0.0P2) Introduced on the S3048-ON.

9.7(0.0) Introduced on the S6000-ON.

9.2(1.0) Introduced on the Z9500.

9.0.2.0 Introduced on the S6000.

8.3.19.0 Introduced on the S4820T.

8.3.11.1 Introduced on the Z9000.

8.3.7.0 Introduced on the S4810.

7.6.1.0 Introduced on the S-Series.

7.5.1.0 Introduced on the C-Series.

6.1.1.0 Introduced on the E-Series.

ntp multicast client

To receive NTP information from the network via multicast, configure the switch.

Syntax

ntp multicast client [multicast-address]

To disable multicast reception, use the no ntp multicast client [multicast-address]

command.

Parameters

multicast-

address

(OPTIONAL) Enter a multicast address. Enter either an IPv4 address in dotted

decimal format or an IPv6 address in X:X:X:X::X format. If you do not enter a

multicast address, the address:

● 224.0.1.1 is configured if the interface address is IPv4

● ff05::101 is configured if the interface address is IPv6

Defaults Not configured.

Command Modes INTERFACE

Command

History

This guide is platform-specific. For command information about other platforms, see the relevant Dell

EMC Networking OS Command Line Reference Guide.