Setup Guide

The system supports loading two DCB_Config files:
• FCoE converged traffic with priority 3.
In the Dell EMC Networking OS, PFC is implemented as follows:
• PFC is supported on specified 802.1p priority traffic (dot1p 0 to 7) and is configured per interface. However, only one lossless queue is
supported on an interface: one for Fibre Channel over Ethernet (FCoE) converged traffic. Configure the same lossless queues on all
ports.
• PFC delay constraints place an upper limit on the transmit time of a queue after receiving a message to pause a specified priority.
• By default, PFC is enabled on an interface with no dot1p priorities configured. You can configure the PFC priorities if the switch
negotiates with a remote peer using DCBx
• During DCBx negotiation with a remote peer:
• DCBx communicates with the remote peer by LLDP TLV to determine current policies, such as PFC support and ETS bandwidth
allocation.
• If DCBx negotiation is not successful (for example, a version or TLV mismatch), DCBx is disabled and PFC or ETS cannot be enabled.
• PFC supports buffering to receive data that continues to arrive on an interface while the remote system reacts to the PFC operation.
• PFC supports buffering to receive data that continues to arrive on an interface while the remote system reacts to the PFC operation.
• PFC uses DCB MIB IEEE 802.1azd2.5 and PFC MIB IEEE 802.1bb-d2.2.
• A dynamic threshold handles intermittent traffic bursts and varies based on the number of PFC priorities contending for buffers, while
a static threshold places an upper limit on the transmit time of a queue after receiving a message to pause a specified priority. PFC
traffic is paused only after surpassing both static and dynamic thresholds for the priority specified for the port.
• By default, PFC is enabled when you enable DCB. If you have not loaded FCoE_DCB_Config_DCB_Config, DCB is disabled. When you
enable DCB globally, you cannot simultaneously enable link-level flow control.
• Buffer space is allocated and de-allocated only when you configure a PFC priority on the port.
Enhanced Transmission Selection
Enhanced transmission selection (ETS) supports optimized bandwidth allocation between traffic types in multiprotocol (Ethernet, FCoE,
SCSI) links.
ETS allows you to divide traffic according to its 802.1p priority into different priority groups (traffic classes) and configure bandwidth
allocation and queue scheduling for each group to ensure that each traffic type is correctly prioritized and receives its required bandwidth.
For example, you can prioritize low-latency storage or server cluster traffic in a traffic class to receive more bandwidth and restrict best-
effort LAN traffic assigned to a different traffic class.
NOTE:
Use the following command to enable etsacl: cam-acl l2acl 2 ipv4acl 2 ipv6acl 0 ipv4qos 0 l2qos
0 l2pt 0 ipmacacl 0 vman-qos 0 fcoeacl 2 etsacl 3. After executing this command, you must save the
configuration and then reload the system.
The following figure shows how ETS allows you to allocate bandwidth when different traffic types are classed according to 802.1p priority
and mapped to priority groups.
Figure 30. Enhanced Transmission Selection
The following table lists the traffic groupings ETS uses to select multiprotocol traffic for transmission.
236
Data Center Bridging (DCB)