Setup Guide

seq 15 permit ip any host 1.1.1.3
seq 20 permit ip any host 1.1.1.4
DellEMC# end
DellEMC# resequence access-list ipv4 test 2 2
DellEMC# show running-config acl
!
ip access-list extended test
remark 2 XYZ
remark 4 this remark corresponds to permit any host 1.1.1.1
seq 4 permit ip any host 1.1.1.1
remark 6 this remark has no corresponding rule
remark 8 this remark corresponds to permit ip any host 1.1.1.2
seq 8 permit ip any host 1.1.1.2
seq 10 permit ip any host 1.1.1.3
seq 12 permit ip any host 1.1.1.4
Route Maps
Although route maps are similar to ACLs and prefix lists in that they consist of a series of commands that contain a matching criterion and
an action, route maps can modify parameters in matching packets.
Implementation Information
ACLs and prefix lists can only drop or forward the packet or traffic. Route maps process routes for route redistribution. For example, a
route map can be called to filter only specific routes and to add a metric.
Route maps also have an “implicit deny.” Unlike ACLs and prefix lists; however, where the packet or traffic is dropped, in route maps, if a
route does not match any of the route map conditions, the route is not redistributed.
The implementation of route maps allows route maps with the no match or no set commands. When there is no match command, all
traffic matches the route map and the set command applies.
Access Control Lists (ACLs)
123