Deployment Guide

Viewing the Configuration Lock Status
If you attempt to enter CONFIGURATION mode when another user has locked it, you may view which user has control of
CONFIGURATION mode using the show configuration lock command from EXEC Privilege mode.
You can then send any user a message using the send command from EXEC Privilege mode. Alternatively, you can clear any line
using the clear command from EXEC Privilege mode. If you clear a console session, the user is returned to EXEC mode.
Example of Locking CONFIGURATION Mode for Single-User Access
DellEMC(conf)#configuration mode exclusive auto
BATMAN(conf)#exit
3d23h35m: %RPM0-P:CP %SYS-5-CONFIG_I: Configured from console by console
DellEMC#config
! Locks configuration mode exclusively.
DellEMC(conf)#
If another user attempts to enter CONFIGURATION mode while a lock is in place, the following appears on their terminal
(message 1): % Error: User "" on line console0 is in exclusive configuration mode.
If any user is already in CONFIGURATION mode when while a lock is in place, the following appears on their terminal
(message 2): % Error: Can't lock configuration mode exclusively since the following users are
currently configuring the system: User "admin" on line vty1 ( 10.1.1.1 ).
NOTE: The CONFIGURATION mode lock corresponds to a VTY session, not a user. Therefore, if you configure a lock
and then exit CONFIGURATION mode, and another user enters CONFIGURATION mode, when you attempt to re-enter
CONFIGURATION mode, you are denied access even though you are the one that configured the lock.
NOTE: If your session times out and you return to EXEC mode, the CONFIGURATION mode lock is unconfigured.
Recovering from a Forgotten Password on the S6000
If you configure authentication for the console and you exit out of EXEC mode or your console session times out, you are
prompted for a password to re-enter.
If you forget your password, follow these steps:
1. Log onto the system using the console.
2. Power-cycle the chassis by disconnecting and then reconnecting the power cord.
3. During bootup, press Esc when prompted to abort the boot process.
You enter Boot-Line Interface (BLI) mode at the BOOT_USER# prompt.
4. At the BLI prompt, set the system parameter to ignore the enable password and reload the system:
BOOT_USER# ignore enable-password
BOOT_USER# reload
NOTE:
You must manually enter each CLI command. The system rejects a command if you copy and paste it in the
command line.
5. Configure a new password.
CONFIGURATION mode
enable {secret | password}
6. Save the change in the running configuration to the startup configuration.
EXEC Privilege mode
copy running-config startup-config
Management
77