API Guide

ip ecmp weighted
Enables weighted ECMP calculations.
C9000 Series
Syntax
ip ecmp weighted
To disable weighted ECMP calculations, enter the no ip ecmp weighted command.
Defaults N/A
Command Modes CONFIGURATION
Command History
Version Description
9.9(0.0) Introduced on the C9010.
9.7(0.0) Introduced on the S-Series.
Usage Information
Enabling this CLI would inform the FIB to re-program the destination prefix paths with weights in the HW/CAM
on the fly.
If disabled, the CLI would inform the FIB to re-program the destination prefix paths with no weights or regular
ECMP.
Example
Dell(conf)#ip ecmp ?
weighted Enables Weighted ECMP
Dell(conf)#ip ecmp weighted
Dell(conf)#do show running-config | grep ecmp
ip ecmp weighted
Dell(conf)#
Dell(conf)#no ip ecmp ?
weighted Disables Weighted ECMP
Dell(conf)#no ip ecmp weighted
Dell(conf)#do show running-config | grep ecmp
link-bundle-distribution trigger-threshold
Provides a mechanism to set the threshold to trigger when traffic distribution begins being monitored on an ECMP link bundle.
C9000 Series
Syntax
link-bundle-distribution trigger-threshold [percent]
To exit from ecmp group mode, use the exit command.
Parameters
percent Indicate the threshold value when traffic distribution starts being monitored on an ECMP
link bundle. The range is from 1 to 90%. The default is 60%.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
628 Equal Cost Multi-Path (ECMP)