API Guide

Version Description
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.1.1.0 Introduced on the E-Series.
mac control-plane egress-acl
Enable user egress ACL for L2 control traffic on control plane.
C9000 Series
Syntax
mac control-plane egress-acl
Parameters None
Defaults None
Command Modes
CONFIGURATION
CONFIGURATION TERMINAL BATCH
Error Strings NONE
Command History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.10(0.0) Introduced the Configuration Terminal Batch mode on C9010.
9.9(0.0) Introduced on the C9010.
Usage Information
Use this command in Configuration Terminal Batch mode to enable user egress ACL for L2 control traffic in a
dual-homing setup.
mac access-group
Apply a MAC ACL to traffic entering or exiting an interface. You can apply a MAC ACL on a physical, port-channel, or VLAN interface.
C9000 Series
Syntax
mac access-group access-list-name {in [vlan vlan-range] | out}
To delete a MAC access-group, use the no mac access-group mac-list-name command.
Parameters
access-list-name Enter the name of a configured MAC access list, up to 140 characters.
vlan vlan-range (OPTIONAL) Enter the keyword vlan and then enter a range of VLANs. The range is
from 1 to 4094 (you can use IDs 1 to 4094).
NOTE: This option is available only with the keywordin option.
in Enter the keyword in to configure the ACL to filter incoming traffic.
out Enter the keyword out to configure the ACL to filter outgoing traffic.
Defaults none
Access Control Lists (ACL) 255